Debugging steps of road shot blasting machine
Chengdu shugong mechanical road shot blasting machines are sold all over the country. When the shot blasting machine arrives at the customer's place, there are special installation personnel on-site service to guide the workers to operate the road shot blasting machine. However, it is the first time that the operator comes into contact with the road shot blasting machine. It is inevitable that there will be omissions in the learning process. In order to better operate the equipment, the editor hereby sorts out the debugging steps of the road shot blasting machine to facilitate better operation. machine.
The first step is to prepare for installation and debugging.
When the road shot blasting machine arrives at the customer, there is no special case. It is loaded on two wooden pallets, one for the main engine and one for the dust collector, and the pipes are bundled separately. Among them, the sand collecting trolley, lifting wrench, and part of the hosting trolley are in the same tray with the host. Except for some hosting trolleys, the cables and calipers are placed in the ash hopper at the bottom of the dust collector. The first step we need to do is to connect the host and the dust collector through cables and pipes, and fix them with a hosting trolley, and fix both ends of the pipes with calipers.
The second step is to debug the road shot blasting machine.
After the host is connected to the dust collector, first start the dust collector power supply, and observe whether the dust collector air compressor is installed with arrows indicating rotation. The same is true for the main machine of the shot blasting machine. After adjusting the rotation to normal, use the lifting wrench to completely put down the road shot blasting machine, so that the cleaning port is completely attached to the cleaning surface, start the power supply of the host and the dust collector, and start the shot blasting test. Control the walking button of the road shot blasting machine, move to the test area, pull down the sand release switch, the shot material will hit the cleaning area from the cleaning port through the shot blasting wheel, and the walking speed of the road shot blasting machine can be adjusted according to the cleaning requirements and time control switch Shot blasting strength.
A few things to note when debugging:
1. The pipe calipers must be tightened and fixed;
2. The main engine and the dust collector must check the rotation direction;
3. Don't forget to completely put down the road shot blasting machine with the lifting wrench before use